locker wasn't done with heat shrink connections. When I cut the
connections there was some corrosion on the vessel side of the wiring.
I trimmed that back to better wire and reconnected the wiring with
Ancor crimp connectors and heat shrink.
This is the maintenance and refit log for our Aloha 34 sailboat, Kaleo. Check out our adventures on her at www.svkaleo.com
I trimmed that back to better wire and reconnected the wiring with
Ancor crimp connectors and heat shrink.
Now we can both easily read.
I removed the chimney outlet from the former propane water heater, and
enlarged the whole by about a 1/2". I then epoxied the deck core with
west systems un-thickened. After that dried I siliconed in the inside
trim ring then siliconed the outer vent in.
Since it's solar powered with a battery for backup this should lead to
constant fresh air in the head. I will have to test whether is should
run on exhaust or intake.